judgeday
GF Ouro
- Entrou
- Set 23, 2006
- Mensagens
- 1,835
- Gostos Recebidos
- 1
SKYBOX F3 recovery kit for bricked or fail boot.
Thanks to the author/s of this kit
Thanks Also to Matrix For Explaining The Howto i have just added the pics to make it easier
Instructions
MY EROM FOLDER WAS ON MY DESKTOP
1.Connect your RS232 LEAD to the SKYBOX F3
2.Now select corresponding port on the erom software.
3.Press upgrade & select the skybox f3.abs enclosed in the erom folder.
4.Switch off the SKYBOX F3 at the rear of the box.
5.Now press "NEXT" then turn the box on at the back you will now see "Com Port OK and the blue bar start to fill up"
6.The loader will now start loading slowly. (allow the firmware time to load even if it hangs at the end wait for completion and it will reboot once completed)
If it fails to start loading,turn the box off via the rear power switch & again press "NEXT" then turn the reciever back on,it may take several times before the box starts to load the firmware.
reuploaded without password
Thanks to the author/s of this kit
Thanks Also to Matrix For Explaining The Howto i have just added the pics to make it easier
Instructions
MY EROM FOLDER WAS ON MY DESKTOP
1.Connect your RS232 LEAD to the SKYBOX F3
2.Now select corresponding port on the erom software.
3.Press upgrade & select the skybox f3.abs enclosed in the erom folder.
4.Switch off the SKYBOX F3 at the rear of the box.
5.Now press "NEXT" then turn the box on at the back you will now see "Com Port OK and the blue bar start to fill up"
6.The loader will now start loading slowly. (allow the firmware time to load even if it hangs at the end wait for completion and it will reboot once completed)
If it fails to start loading,turn the box off via the rear power switch & again press "NEXT" then turn the reciever back on,it may take several times before the box starts to load the firmware.
reuploaded without password
Última edição: